SOLVE ELEC SETUP HOW TO

I can add a new 4 phase system, Delta, 3 wires, but the L-L & L-G voltages only allow up to 480V, where as the service transformer primary is clearly 120000v. Yes, however the electrical settings will not allow greater than 480V. Nothing seems intuitive, easy, or in some cases possible.ġ. I too have been finding this out as I get more in dept with Revit. I can extend conduits from my sub panels to the MDP and circuit my sub panel to the MDP, but how do you tell revit the circuits actually run inside the conduits with appropriate wire lenghts (including elevation changes) taken into account? I assume this would be the same for my MDP to SVC Trans but can't circuit it yet? Can someone please help here too?

SOLVE ELEC SETUP HOW TO

I haven't found anyhwere that explains how to model the grounding rod(s) & locations then assign the MDP to it (them). How do I change the power system from & actually assign it within the Electrical Circuits Ribbon/ Systems tools section/ System Selector:?ģ. The system browser lists my my service transformer under Electrical/ Power/, SVC Trans (the name I gave it is SVC Trans). As such I can't assign my 480v MDP to the service transformer. I can load & place the wet type 12000v to 480/277Y service transformer but can't seem to assign it to a 12000v (Utility Company's) distribution system in the electrical settings.

I need help creating a full electrical distribution system that includes the service transformer and building ground.

Solve elec setup